LEDs and sounds

This section lists LED indications and haptic feedback signals used by the camera.

Description Operation LED Function LED Battery LED
Battery capacity (press Battery status, front bottom)     A small rectangle representing the LED color. Green: 40–100%
A small rectangle representing the LED color. Yellow: 20–39%
A small rectangle representing the LED color. Red: <20%
Bluetooth connecting   A small rectangle representing the LED color. Blue  
Clock not set or error A small rectangle representing the LED color. Red A small rectangle representing the LED color. Red  
Event (Recording) mode (including if started by Axon Signal*) A small rectangle representing the LED color. Blinking red   A small rectangle representing the LED color. Blinking red**
Mute mode   A small rectangle representing the LED color. Blinking blue  
Powering on/off A small rectangle representing the LED color. Red    
Ready (Buffering) mode (if configured) A small rectangle representing the LED color. Blinking green   A small rectangle representing the LED color. Blinking green**
Recovering interrupted video A small rectangle representing the LED color. Blinking red A small rectangle representing the LED color. Blinking red  
View XL, connecting (Fleet only)   A small rectangle representing the LED color. Blinking purple  
View XL, connected (Fleet only)   A small rectangle representing the LED color. Purple  

* May not be enabled at your agency. ** If configured to mimic Operation LED.

LEDs while docked

The round Battery LED on the front of the camera and Status LED on the bottom (top when docked) shows information while docked.

Description Battery LED
Battery charging – LED colors show the charge level. A small rectangle representing the LED color. Green: >98%
A small rectangle representing the LED color. Yellow: 20–98%
A small rectangle representing the LED color. Red: <20%

 

Description Status LED
Dock has no communication with the camera. Ensure the camera is fully seated and the dock core and bays are properly connected. LED off
Error – Device not assigned, agency mismatch, camera in offline mode, or device error A small rectangle representing the LED color. Blinking red
Error, Transfer – Data transfer error, re-trying A small rectangle representing the LED color. A small rectangle representing the LED color.
Blinking green and yellow
Network error – Verify dock is registered (see dock manual) A small rectangle representing the LED color. A small rectangle representing the LED color. A small rectangle representing the LED color.
Blinking red, yellow, and green (all colors)
Updating, charge, or memory – Firmware update, battery charging, extremely low battery, or memory full; DO NOT remove camera from dock A small rectangle representing the LED color. A small rectangle representing the LED color.
Blinking red and yellow
Video queued, waiting to upload A small rectangle representing the LED color. Yellow
Video uploading A small rectangle representing the LED color. Blinking yellow
Video uploaded, device ready A small rectangle representing the LED color. Green

Audible and haptic notifications

The camera emits audio prompts to notify you of device status. These prompts are accompanied by a vibration (haptic feedback). These prompts usually occur after you perform an action with the camera.

Operating Mode or Action Audio Notification (beep) Haptic Notification
(vibration)
Battery low, buffering (<20 minutes remaining) Four every 20 seconds Four every 20 seconds
Battery low, recording (<3 minutes remaining) Four every 20 seconds Four every 20 seconds
Camera memory full Three Three
Internal clock not set or error (Operation and Function LEDs also solid red A small rectangle representing the LED color.) Five every 20 seconds Five every 20 seconds
Power on or off One One
Recording Two at start and every two minutes Two, every two minutes
Recording stop, return to Ready mode One, long One, long duration