Radio waves
An Axon Signal Vehicle system transmission is in the frequency range of 2402–2480 MHz.
Changes or modifications to the equipment not expressly approved by the manufacturer could void the product warranty and your authority to operate the equipment.
Your wireless device is a radio transmitter and receiver. It is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission (FCC) of the U.S. Government. These limits are part of comprehensive guidelines and establish permitted levels of RF energy for the general population. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons, regardless of age and health. Before a device model is available for sale to the public, it must be tested and certified to the FCC that it does not exceed the limit established by the government-adopted requirement for safe exposure.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult Axon Enterprise Technical Support for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
To comply with FCC RF exposure limits for general population / uncontrolled exposure, the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.
Section 8.4 of RSS-GEN
This Device complies with Industry Canada License-exempt RSS standard(s). Operation is subject to the following two conditions: 1) this device may not cause interference, and 2) this device must accept any interference, including interference that may cause undesired operation of the device.
Cet appareil est conforme aux normes d’exemption de licence RSS d’Industrie Canada. Son utilisation est soumise aux conditions suivantes : 1) cet appareil ne doit pas causer de brouillage, et 2) doit accepter tout brouillage, y compris le brouillage pouvant entraîner un fonctionnement indésirable.
Section 8.3 of RSS-GEN
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be chosen so that the equivalent isotropically radiated power (e.i.r.p.) is not greater than necessary for successful communication.
To comply with IC RF exposure limits for general population/uncontrolled exposure, the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.
Conformément à la réglementation d’Industrie Canada, le présent émetteur radio ne peut fonctionner qu’au moyen d’une antenne d’un seul type et d’un gain maximal (ou inférieur) approuvé pour l’émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage radioélectrique pour les autres utilisateurs, il faut choisir le type d’antenne et son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas celle requise pour établir une communication satisfaisante.
Pour se conformer aux limites d’exposition aux radiofréquences fixées par Industrie Canada relativement aux limites d’exposition humaine, l’antenne utilisée pour cet émetteur doit être installée à une distance d’au moins 20 cm de toutes les personnes et ne doit pas être installée ou exploitée conjointement avec d’autres antennes ou émetteurs.
Section 6.8 of RSS-GEN
This radio transmitter IC: 8803A-S00831 has been approved by Innovation, Science and Economic Development Canada to operate with the antenna type listed below, with the maximum permissible gain indicated. Antenna types not included in this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited for use with this device.
Axon Signal Vehicle uses a Surface Mount Chip Antenna. Antenna gain is <0.5dBi. The required impedance for this antenna is 50 ohms.
Declaration of conformity
Axon declares that this Axon system is compliant with the requirements of the Radio Equipment Directive (RED) 2014/53/EU. A copy of the original Declaration of Conformity can be found at www.axon.com.
Compliance marks
|
|
|
|
 
RCPAXT018-0159 |
Complies with IMDA Standards DA106455 | 
|
|
|
AGREE PAR L’ANRT MAROCNuméro d’agrément : MR00039816ANRT2023Date d’agrément : 05/09/2023 | ||
ANATEL (Brazil) Compliance Information
MSIP (South Korea) Compliance Information
Applicant Name: Axon Enterprise, Inc.
Manufacturer/Manufacturer Country: Axon Enterprise, Inc. / USA
Name of equipment/model name: Axon Signal Vehicle / T00504
Certification Numbers: MSIP-CRM-CEW-T00504
Year of manufacture: separate marking
Last modified - 20 May 2026
