Audio Prompts

The Axon Flex 2 camera emits beeping sounds called “audio prompts” to notify you of the system status. These audio prompts usually occur after you perform an action with the body camera. Audio prompts are accompanied by vibration patterns that match the beeps.

Operating Mode	Audio Notification	Haptic Notification (Vibration)
Powering on or off	One beep	Once
Recording an event	Two beeps (every 2 minutes)	Twice (every 2 minutes)
Press the Battery button while recording	Two beeps	None
The device is ending an event and returning to BUFFERING mode	One long beep	Once, long-duration
Low battery notifications: Camera in BUFFERING mode and battery has 20 minutes or less (camera will not record) Camera in EVENT mode and battery nearly discharged (camera will shut down within a few minutes)	Four quick beeps (every 20 seconds)	Four quick vibrations (every 20 seconds)
Cable disconnect (camera will shut down)	Three beeps	Six vibrations
The camera memory is full (camera will not record)	Three beeps	Three vibrations
The camera internal clock is not set. Place in an Axon Dock or connect to Evidence Sync to correct this issue.	Five quick beeps (every 20 seconds)	Five quick vibrations (every 20 seconds)