Introduction
Overview
Signal Sensor (SSR) sends a signal to Axon cameras when a user draws their firearm or other assigned device. It attaches to popular duty holsters and is powered by an off-the-shelf coin cell battery.
Signal Sensor is recommended for use on:
- Axon Body 3 and later cameras
- Axon Fleet 3 and later vehicle cameras
It is also supported on Axon Body 2, Flex 2, Body Workforce, and Fleet 2 cameras. Contact your Axon representative to enable Compatibility mode if you use these cameras.
Signal Sensor can also be used with other devices such as handcuffs, pepper spray, or a baton via specific pouches. This manual provides instruction for its most common use with a firearm; its use with those other devices is similar.
A Signal Sensor can NOT be physically swapped between holsters or pouches at will. Calibrate or recalibrate the sensor before use if it is moved to another a holster or pouch.
Important safety instructions
Read all warnings and instructions. Save and follow these safety instructions.
The most up-to-date warnings and instructions are available at www.axon.com/legal.
Product functions and specifications may change without notice and the actual product may vary from the illustrations in this document.
Read these warnings prior to using this sensor.
- Please read and carefully follow all sensor installation and operation instructions. Failure to follow these instructions may result in improper installation which could interfere with the holster’s performance.
- Do not install the sensor in a way that interferes with the proper functioning of the holster.
- Do not install the sensor while a firearm is in the holster.
- Use great care when handling, storing or transporting firearms or when placing or removing a firearm from a holster.
- If a holster fitted with a sensor becomes worn, loose, broken, defective or ill-fitting, or unsafe, cease use immediately.
Failure to follow these warnings may result in serious injury or death to you or others.
In daily use, keep Axon Signal Sensor away from magnets or magnetic devices, such as speakers and magnetic mounts used with a body camera. Contact with a magnet will not damage the sensor but could cause it to signal nearby cameras to begin recording.
